N-XTC APPLICATOR (WITHOUT MICROSUEDE TOWELS)

N-XTC.com - N_ACC_006, Use to apply N-XTC Sync. Quartz Coat 4D and N-XTC Synt. Coat Finish 3D

Availability: In stock

Details
Details

Why buy this product
Good value for money.
Perfect applicator to apply paint (quartz) coatings.
Ultra soft applicator foam to follow all curves on every panel.

About this product
Wrap with a N-XTC Suede Microfiber Towel
Use to apply N-XTC Sync. Quartz Coat 4D and N-XTC Synt. Coat Finish 3D
With the N-XTC Quartz coatings this allows you to change the applicator towel as needed because you cannot re-use these if you have allowed the coating to cure on them.

Directions:
Wrap with a N-XTC Suede Microfiber Towel.
Dispose the used N-XTC Suede Microfiber Towel and replace as needed after use with N-XTC Sync. Quartz Coat 4D or N-XTC Synt. Coat Finish 3D.

If using a foam block with something other than N-XTC do not use the same foam block for application of any other coatings. Immediately after use gently rinse applicator side of foam block, press dry, and allow to air dry completely before next use.  When in doubt replace... A small amount to avoid future contamination is well worth your hundreds of euro`s worth of time.

Specifications

Size 8cm x 4cm x 2cm
Material Stiff foam with ultra-soft applicator foam on applicator side
Reviews
Write Your Own Review
You're reviewing: N-XTC APPLICATOR (WITHOUT MICROSUEDE TOWELS)